Overview
The Liteguide Controller AE1000 carries out EPC (Edge Position Control) through a combination of Photoheads (PH16B) and Ultrasonic Sensor (UH01), CPC (Center Position Control) through a combination of Photoheads and Autowide Sensor (AWE280 etc.) and LFC (Line Follower Control) through a combination of LH19 and LH110.
Feature
- Liteguide Controller AE1000 is the successor to the previously well established AE900E and AE900L controllers.
- This single type can be connected to Nireco standard sensors which has been used with the AE900E or AE900L controller.
(Some sensors may need to be used with a preamp) - Can be used directly coupled with electrical actuators K12 and K61. Can also be connected to the K80 series through use of a driver.
- Has 2 systems, a sensor input stage and a shift input stage, which can be switched for use.
- Uses a larger LCD display than previous models with a white backlight making it both easier to see and allowing for verification of a greater amount of information.
Configuration

Specification
Power Supply Voltage | AC100 to 240V 50/60Hz ±10% | |
---|---|---|
Power Consumption | 300 VA (inrush current 100 A 10 ms typical (200 V)) | |
Power Fuse | 250V AC, 3.15 A (time-lag type) | |
Ambient Operating Temperature |
0 to 50°C | |
Ambient Operating Humidity |
35 to 85% RH or lower (no condensation) | |
Vibration Resistance | 3.5 mm, 1 G, 3 to 150 Hz, three-directions (1hour) | |
Power supply Noise | 2.5 kVp-p, normal mode, common mode 50 ns, 1μs width | |
Usage atmosphere: | Area with no water, flammable or corrosive gases, and little dust. | |
Mass | Approximately 5 kg | |
IP Class | IP30 |
Input
2 Sensor systems | Voltage input Maximum ±5V(No input resistance) Current input 0-20mA (input resistance converted to 240/2kΩ) |
---|---|
2 analog shift systems | Voltage input Maximum ±10V |
Centering | Proximity switch input (0-8V, 1.2kΩ input resistance)(Applies to: KL1632. 0-90P) |
Position Transmitter | Voltage input Maximum ±10V |
Photo coupler input (12V DC, 15mA) |
Remote controller :
Actuator end limit :
|
Output
Electrical actuator | K12 ±24V DC, 1A(maximum) or K62 ±36V DC, 2A(maximum) |
---|---|
Lamp power source | 4 to 12V DC, variable (maximum 1A) |
Fine tuner, Position transmitter, LH8B |
±5V power source (maximum 0.1A) |
Sensors | ±15V power source (+15V, 1A; -15V, 0.2A) (Note: The current capacity on the + side combined with the lamp power source in(2) is less than 1A.) |
Centering proximity switch power source |
8V DC (maximum 30mA) |
2 indicator systems | Voltage output Maximum ±10V (load resistance 2kΩ or greater) Deviation output Position transmitter output |
Photo coupler output (24V DC, 40mA) |
Remote controller :
|